HD video conference camera installation notes
During the installation process, the power cable must be led near the video conference camera. At the same time, the line of the power adapter of the conference camera must not be extended, and the centralized power supply mode must not be used. Causes The conference camera supplies power in a centralized manner. The voltage to the conference camera is sometimes insufficient. Especially in thunderstorms, resistance resistance increases. Insufficient power supply may cause the board of the conference camera to burn off and thus cannot be controlled.
When wiring, remember to distinguish RS485 protocol communication line and power line. If RS485 is connected to the power supply, the conference camera may be burned on the spot, so do the relevant logo to facilitate its own convenient future maintenance. It is very important to test the conference camera and choose the right power source. Why? If the power is too high, the conference camera will be burned out. The power is too low to reach the rated power of the conference camera. The capacitance of the main control board of the conference camera will continue to discharge, which will damage the components of the conference camera. This shortens the life of the conference camera.
After you get the conference camera, remember that the entire process is easy to handle. Because you love your HD conference camera, it will "reward" you, that is, lower failure rate and longer life. Usually the above steps are completed smoothly, and the installation procedure of the entire conference camera is almost the same. Now all you have to do is to re-examine whether the entire process is correct.